Often you must have seen that the bathroom faucet starts to look bad due to hard water in no time. Not only this, but many times it also happens that due to dirty tap or due to accumulation of salty water in the pipe, water stops coming from it.
In most cases, this problem is caused due to dirty tap. In such a situation, there is no need to spend a lot of money by calling a plumber. If the only problem is that the tap is dirty, then it can be easily cleaned.
Yes, if the water wipes need to be changed or if there is a problem with the waterline, then it is another matter where you need to hire South West Plumbing has great plumbers, but usually, if it is only a problem with the tap then it can be easily cleaned.
What are the materials needed for cleaning?
- Baking soda
- White vinegar
- lemon peel
- Harpic Spray
Clean the nozzle of the tap-
First of all, the nozzle of the tap (the part from which the water comes out) should be cleaned. Most of the taps have a mesh on this part so that the water flow is uniform. Trash often accumulates in this mesh, and in most cases just cleaning it will do the job. You remove the nozzle of your faucet and wipe the mesh with a cloth. You should also check its holes once so that no spray hole gets spoiled.
Clean the rust stain-
Corrosion can also be the reason for the lack of water in the tap. They neither look good nor are they safe. This can also contaminate the water and for this, you should always clean such rust stains.
How to do-
Mix equal amounts of white vinegar and baking soda and then apply this paste to the rust stain. Take a little of this paste in an old toothbrush and apply it to the nozzle of the tap and try to clean it. Leave it like this for 10 minutes and after that clean the tap with a cloth and water. Rust stains will be gone.
South West Plumbing has great plumbers, for bigger issues you can hire them. Visit https://www.southwestplumbing.biz/plumbing/ to get detailed information.
